6
FN9038.4
March 9, 2006
shuts down both regulators simultaneously when the fault
signal triggers a restart.
Figure 2 illustrates the protection feature responding to an
UV event on V
OUT1
. At time T0, VOUT1 has dropped below
52.5% of the nominal output voltage. Both outputs are
quickly shut down and the internal soft-start function begins
producing soft-start ramps. The delay interval, T0 to T3,
seen by the output is equivalent to three soft-start cycles.
After a short delay interval of 10.5ms, the fourth internal soft-
start cycle initiates a normal soft-start ramp of the output, at
time T3. Both outputs are brought back into regulation by
time T4, as long as the UV event has cleared.
Had the cause of the UV still been present after the delay
interval, the UV protection circuitry becomes active
approximately 875祍 into the soft-start interval. A fault signal
could then be generated and the outputs once again
shutdown. The resulting hiccup mode style of protection
would continue to repeat indefinitely.
Output Voltage Selection
The output voltage of the PWM converter can be
programmed to any level between V
IN
 (i.e. +3.3V) and the
internal reference, 0.8V. An external resistor divider is used
to scale the output voltage relative to the reference voltage
and feed it back to the inverting input of the error amplifier,
see Figure 3. However, since the value of R1 affects the
values of the rest of the compensation components, it is
advisable to keep its value less than 5k&. Depending on the
value chosen for R1, R4 can be calculated based on the
following equation:
If the output voltage desired is 0.8V, simply route VOUT1
back to the FB pin through R1, but do not populate R4.
FIGURE 1. SOFT-START INTERVAL
0V
0V
TIME
+5V (VCC)
(0.5V/DIV)
T1
T2
T0
(1V/DIV)
+3.3V (UPPER FET DRAIN)
V
OUT1
 (1.5V)
V
OUT2
 (2.5V)
R4
R1 0.8V
?/DIV>
V
OUT1
0.8V

--------------------------------------
=
(EQ. 1)
FIGURE 2. UNDERVOLTAGE PROTECTION RESPONSE
0V
0V
TIME
V
OUT2
 (2.5V)
T1
T2
T3
T0
T4
(0.5V/DIV)
V
OUT1
 (1.5V)
Internal Soft-Start Function
V
OUT2
 (2.5V)
Delay Interval
Delay Interval
FIGURE 3. OUTPUT VOLTAGE SELECTION OF THE PWM
+
R1
C
OUT1
+5V
+3.3V
V
OUT1
R4
L
OUT
ISL6528
C4
Q1
FB
UGATE
VCC
BOOT
COMP
D1
D2
R2
C1
C2
R3
C3
ISL6528
相关PDF资料
ISL6529CBZ IC REG DL BCK/LINEAR SYNC 14SOIC
ISL6534CVZ-TR5229 IC REG 3OUT BCK/LINEAR 24EPTSSOP
ISL6549CRZR5213 IC REG DL BCK/LINEAR SYNC 16-QFN
ISL9305IRTHWLNCZ-T IC REG QD BUCK/LINEAR 16TQFN
ISL9305IRTWLNCZ-T IC REG QD BUCK/LINEAR 16TQFN
ISL9307IRTWCWNZ-T IC REG QD BCK/LINEAR SYNC 16TQFN
IXCP10M90S IC CURRENT REGULATOR TO220AB
IXCY10M45S IC CURRENT REGULATOR DPAK
相关代理商/技术参数
ISL6529ACB 功能描述:IC REG DL BCK/LINEAR 14-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压(降压)同步(3),线性(LDO)(2) 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
ISL6529ACB-T 功能描述:IC REG DL BCK/LINEAR 14-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压(降压)同步(3),线性(LDO)(2) 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
ISL6529ACR 功能描述:IC REG DL BCK/LINEAR SYNC 16-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压(降压)同步(3),线性(LDO)(2) 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
ISL6529ACR-T 功能描述:IC REG DL BCK/LINEAR SYNC 16-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压(降压)同步(3),线性(LDO)(2) 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
ISL6529CB 功能描述:IC REG DL BCK/LINEAR 14-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压(降压)同步(3),线性(LDO)(2) 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
ISL6529CB-T 功能描述:IC REG DL BCK/LINEAR 14-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压(降压)同步(3),线性(LDO)(2) 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
ISL6529CBZ 功能描述:电压模式 PWM 控制器 DLG-SYNCH BUCK & LINEAR PWR CONTROLLE RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel
ISL6529CBZ-T 功能描述:电压模式 PWM 控制器 DLG-SYNCH BUCK & LINEAR PWR CONTROLLE RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel